AiMonkeyGRIP manual
PREPARATION
Necessary tool:
Hex key #3
INSTALL
Remove screws, open arms
Retract on the handlebars and close your arms
ATTRACT
Screw in screws, align
Tighten until the gap disappears
Tip
If the AiMonkeyGRIP sinks slightly while driving or you want to protect the handlebars, you can use fabric adhesive tape
Glue 1 layer with approx. 1cm overlap and then mount the AiMonkeyGRIP. So he stays in place.
compatibility list
BASE K
Necessary bike computer mount
K-Edge>® Replace Insert Kit (Wahoo, Sigma and Garmin)
Compatible devices
For example: Wahoo, Sigma and Garmin bike computers that can be mounted with a K-Edge® mount
BASE LONG
Up to 3 devices can be mounted with HOLDER M or G
BASE SHORT
Up to 2 devices can be mounted with HOLDER M or G
-
-
BASE M
Necessary bike computer mount
Rubber strap and O-ring mounts
Compatible devices
Devices that can be attached to the bike with rubber bands or O-rings
BASE LONG
Up to 3 devices can be mounted with HOLDER M or G
BASE SHORT
Up to 2 devices can be mounted with HOLDER M or G
HOLDER M
(Compatible with all BASE)
Extension for 1 additional device that is mounted with rubber bands or O-ring attachment.